[ltt-dev] UST - Problems in recording trace on a current process

[Naren]

Hi,

Somuya... thanks for the heads up.

Autoconf worked but unfortunately "make" fails. It gives this error
http://pastebin.ca/1791368 .

Regards,
Naren

On Tue, Feb 9, 2010 at 6:45 AM, Pierre-Marc Fournier <
pierre-marc.fournier at polymtl.ca> wrote:

> soumyakanti chakraborty wrote:
> > Hi Pierre
> >
> > I am still getting the same errors during the tracing of a particular
> > process with specific pid's -
> >
> > /ustctl[1605/1605]: Error: connect: No such file or directory (in
> > ustcomm_connect_path() at ../libustcomm/ustcomm.c:452)/
> > /ustcmd_send_cmd: could not connect to PID 1283/
> > /error while trying to list markers for PID 1283/
>
> I'm unable to reproduce the problem. Please make sure the new ust was
> completely installed with "make install" (older versions of the libs
> lying around could cause this). Also, try to run ustctl with strace.
> This will tell what socket file it's trying to open. You can then go
> check if the socket file is actually where it's looking for it.
>
> Thanks!
>
> _______________________________________________
> ltt-dev mailing list
> ltt-dev at lists.casi.polymtl.ca
> http://lists.casi.polymtl.ca/cgi-bin/mailman/listinfo/ltt-dev
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.casi.polymtl.ca/pipermail/lttng-dev/attachments/20100209/652d931c/attachment-0003.htm>